Autoboat Mockup - BKC PK14

Had to remove the pulley from the eye bolt in the motor head for it wrapped itself around and impeded the shaft from rotating. Instead, I'm just looping the orange parachute cord around the shaft which allows the shaft to rotate freely. Im still able to lift the motor out of the water this way.

Update: I had a 380mm (15") Length x 25mm" ID x 29mm OD" clamshell sleeve" 3D printed up to increase the smaller 1" diameter shaft trolling motors. In this case, I'm using the Watersnake 34lb Venom. I ended up only using 9" of the sleeve to accommodate the Autoboat collar/motor and the GPS adapter by roughing up the powder coat on the trolling motor shaft with a file, brushed on super glue on both surfaces, then attached the sleeve. Below the Autoboat collar/motor is still the original 1" shaft where my T-mount attaches to. So far, everything is SOLID out on the water.

nice sir Doc Mackay❤

Nice video ,,, thank you for sharing ,

Nice lodi thanks for sharing

Love it. I have a new pk13. Looks like I’ll have to swap out the short shank cheap motor. Thanks for the video

Wow amazing

That's cool idol

New friend here❤❤❤

This is awesome!

Watching here , SENDING Support

Great video! AutoBoat is awesome! Cool setup.

PROBINSIYANA AKO Here💚💥❤️SOLID💚💥❤️TTJandFRIENDS💚💥❤️SENDING SUPPORT💚💥♥️