Rethink Everything You Know About Workbenches

Triangles are stronger than squares because the shape means that there is no possibility of pivoting at the corners. The only way for the angle at any corner of a triangle to change is by changing the length of any side. If you're building with rigid materials, that just can't happen without catastrophic failure. With any parallelogram, however, all sides can remain at the same length while also pivoting at each joint. When you whack a triangular brace on, you transform your parallelogram into two triangles.

I just finished making my bench today and it's a winner!!! Since I read all the discussion around the cross bracing I decided to plywood the entire back section. It won't move either way now. This is a great design!

Fantastic work bench, I especially like you showing your mistakes and the fixes for them! Well done.

really good looking work bench, I really like how you solved each problem, I learned from those problems.

That was a joy to watch. Your design is very well thought out.

Super. So well thought out and for every issue you had, you were able to find a solution. Very impressive.

A workbench with a new slant and purpose...smaller size and fold away! Well done and thank you!

I didn't realize that I really need one of these until I saw your video. Thanks for sharing!

Very nice design. I love space saving solutions like this.

This is great, and oh so close to an idea I’ve been working on. Well done. Scott

Very nice concept for a compact work surface. One change I would make if I built one would be to position the hinges so that the table surface when closed does not have a gap. It would only require a modification to the clearance made with the router and the gap would be gone. Nice job!

Nicely done, Thomas! 100% on the parting words, too 👍🏻

I really appreciate your attention to safety!

Now this dubbeling those large clamps to fit the large tabletop board, that is fantastic! I should have known before… so weird I didn’t think of it for my former project, making large 7 feet sliding doors. I managed, however this would have made my day for sure! Thanks man. You’re a craftsman. Like!

Good idea. I'll have to think about this one for my shop. Thank you.

The one problem most people fail to address is leveling the workbench (i.e. most garage floors are not flat or level). Putting 3/8 diameter leveling legs in the bottom of the legs is one solution but that requires a one to get down on their knees every time the workbench is re-positioned. There has to be a better solution but I have yet to see it (other than keeping a box of shims to put under the legs).

Thank you so much for sharing. Hubby and I have been trying to figure out a plan and here you are. Being AMAZING! Thank you!

Well this work bench is certainly KIND of AWESOME! Great job!

That bench is pure awesome Thanks for sharing !

Watching this video, I learn many new things, it's very fun, thanks