USB HDMI Capture Dongle Repair
6,756
Published 2021-08-27
You can grab dongles like this all over the place, use incognito mode if you done like affiliate links:
Amazon - amzn.to/3sSqHd2
Ebay - www.ebay.co.uk/itm/265122395343?mkcid=1&mkrid=710-…
Aliexpress - s.click.aliexpress.com/e/_AMXQ40
This is the Twitch person if you are interested - www.twitch.tv/shippam_
It turns out that 'Likes/Dislikes' and 'Shares' actually help the channel so, if you want to, please click the thumbs up or share the video.
I don't have a Patreon or a regular donate thingy, I get by fine. That said, if you are mega rich and fancy buying me a coffee, breadboards or CMOS ICs - paypal.me/DavidWattsYT
or if you fancy donating something I would find useful then feel free to check out my Amazon wishlist (No pressure) - www.amazon.co.uk/registry/wishlist/29JZFQUC2NZ8V
I put lots of my favourite products and stuff that helps me make video up on this Amazon page - www.amazon.com/shop/davidwatts It is one of those affiliate things.
If you want to get in contact Twitter is probably the best way @mrdavidjwatts
www.davidjwatts.com/
All Comments (21)
-
Good to see you back David.
-
w00p! Wavid is in da house! Da new house!
-
The USB 2 version is printed on the board "HD TO U2_V1.3 2020.10.19."! Furthermore, there is a completely different component placement on the board and there is no heat sink on the CPU. I also have two of these capture cards, which have the same housing, but are differently populated. In addition, the version imprint on the board is also missing on mine.
-
Good to see you back David, another great video!! I do need one of those, they look so handy!
-
Hi David, it was great to watch you again. Good job :)
-
Ive repaired the USB plug on flash drives before. To make it absolutely solid, i scrape off some of the green solder mask on the back of the board with a flat blade screw driver and bridge the gap between the board and shell of the USB plug (shown at 16:05) with a small piece (2cm) of used solder wick. Its a hell of a lot stronger than just soldering the support pins on the side. The USB won't ever bend again .
-
Great job Wavid! I've been using one of those to capture vga from my current project.
-
nice seeing a new video David !
-
Nice repair. Great to see you're still tinkering!
-
Glad to hear from you again David!
-
Good to see you again.
-
Welcome back.
-
Good soldering skills you got ! I am repairing a version of this pcb now. Very small and hard but I’ll do it.
-
I like the wagic wand of Flux, no need to waste any :-) nice to see a video from you Wavid ;-)
-
wow I can't believe you managed to fix it that easily after I smashed it, next time I break something I'll come straight to you
-
Nice to see you again. A finished project is enough qualification to join the maker cast. Hint hint
-
I don't think electricity has been upgraded since version 1. So the wiring should still be ok, new wiring works well as the electrons don’t care if it’s Black and Red or Blue and Brown coloured wires.
-
thanx you've helped allot you've earnt a subscription
-
Even the USB3 versions are only USB2 !
-
Seems to have USB 2.0 chip inside. I was quite surprised they actually used a real USB3 plug instead of just blue USB2 plug.
