How to Form a Concrete Slab in Under 10 Minutes!
133,520
Published 2023-05-19
Products:
PLASTIFORM: www.deco-cretesupply.com/products/forms-expansion-…
NAIL STAKES: www.deco-cretesupply.com/products/forms-expansion-…
QUICDOWEL & BASE: www.deco-cretesupply.com/products/forms-expansion-…
LINE: www.deco-cretesupply.com/products/marking-measurin…
PLATE COMPACTOR: www.deco-cretesupply.com/products/forms-expansion-…
All Comments (21)
-
You are a natural teacher. Very informative video, well done
-
Great Job Jeff,Rod and Jason !
-
Just subscribed. My first video of yours. Great content and commentary. I’ll be watching more. Thanks
-
Going to be building a 24 X 24 shop and am debating on doing my own pad…this was a huge confidence builder for me…love the step by step instruction….ill do it exactly like this…thank you
-
This would look like a government job IF there were 4 or 5 guys sitting on that Bobcat bucket…
-
Great video. Straight to the point.
-
thanks and love the ratio of watchers to workers there at the end!!
-
super helpful! thanks guys
-
Thank You very informative
-
Anyone; I have an existing shed/garage which is sitting on railway ties. I need to remove clay about 4ft b4 putting in a concrete slab. Do I also need to excavate under where the blocks will be?
-
Awesome
-
I put in a 12 x 16. My forms are in and I didn't have rock but compacted the dirt and threw in rebar. It's for a shed. Should I still put in rock or am I good with how i have it? I'm also about a 8 inches away from all sides with the rebar. Any advice would be appreciated.
-
Looks great! I'm about to do a 4.5m x 6m slab for a campervan. Should the rebar stick out the sides or is it best to leave them shorter than the overall length and width of the slab?
-
Would you ever use 3/4 road mix as a base? Local gravel supply does not have 57 limestone
-
what do you do with the center (sprayed) cut-off rebar guide after the concrete has been poured? how do you get it out?
-
Did you all use the rebar stands to keep y rebar level? I am readying a DYI effort. Thanks Scott
-
Where can I see a picture or video of that slab that’s stamped ?
-
I have a spot in the middle of a downstairs driveway that is triangular shaped and surrounded by existing slabs. How would I approach that? One side is the retaining wall, the other 2 are concrete. Would I just clear it out, level/gravel fill, then pour?
-
Do you have a segment on how to remove the existing concrete and pour new concrete?
-
Need to do a flat 16x16 flat slab on a slanted/hill yard for a car parking pad Any suggestions or do you know of a video available ?