How to remove a stuck tap handle | stuck faucet handle
110,775
Published 2023-02-04
I have done several videos on tap replacement and tap repair, some of which you might find useful-
How to reseat a tap- • Tap reseating
How to fit a Grohe tap- • How to fit a Grohe mixer tap | 3/8 ta...
How to replace the cartridge in a mixer tap- • How to replace the cartridge in a mix...
How a tap works- • How a tap works
Repair a leaking stop tap- • Leaking stop tap repair
How to replace a lever tap- • How to replace a lever tap
How to replace a vanity unit tap- • How to change a tap in a vanity unit
How to revive old taps- • How to revive old taps
How to change a kitchen tap- • How to change a kitchen tap 👿
How to service a quarter turn tap- • How to service a quarter turn tap
How to remove a stubborn tap head gear- • How to remove a stubborn tap head gear
Kitchen mixer tap repair- • Kitchen mixer tap repair
Lever tap conversion- • Lever taps | Disabled tap conversion
Fix a leaking tap- • fix leaking tap
How to change a stop tap washer- • How to change a stop tap washer
All Comments (21)
-
I'm from the West Midlands and find accents interesting, yours especially when you pronounce 'there' as 'thur' keep up the good work:)
-
Most valuable advice! Thanks for sharing 😀
-
Great advice! Slide hammer is a great tool! Greetings from the states.
-
Brilliant worked a treat , thank you for the video .
-
If you take the red or blue tap insert out you can rock it side to side with a pair of long nose or an adjustable spanner !! We get it loads in student digs works a treat 👍
-
This was super helpful. Thank you and keep it up
-
Another great tip, and great video THANKS
-
Thank you so much for the tips! I could do it all by myself because of your video! 🤩
-
Amazing 👏 thanks mate for quick DIY
-
Great video !! thanks
-
Great tips. Boiling water technique works great.
-
Thank you for your ending proactive lubricant tips!
-
👍👍👍 Thanks. I found out the hard way. You should always put the plug in place before you start.
-
Tq fortips
-
My Mentor Ultimate Handyman 👍 SUBSTANTIAL Ultimate Handyman From Nick Ayivor from London England UK 🇬🇧
-
Try pouring very hot water on the handle. Wrap a towel around it to soak up the water.
-
Next headache is getting the tap gear head off without rounding the nut 😂😂😂 3/8 deep socket and a 14''' inch breaker bat works for me 💪💪💪💪
-
Is the centre screw always a Phillips or can it be flathead or allen?
-
My suggestion would be before you put the screw back in to coat the threads in vaseline, a few years ago I went to remove a tap and the screw wouldn't budge no matter what I did an ended up having to fit new taps.
-
I'm looking to change the heads on my taps (to a longer handle instead of the ones in this video). Can I do this with the tips in this video or is it more complex?